Wet Gas Flowmeter (CX-WGFM-XML)

Model NO.: CX-WGFM-XML Main Application: Nature Gas, Corrosive Liquid/Gas Certification: CE, SGS, ISO Quality: World-Class Exported: More 80 Countries Trademark: gn Origin: Shanghai Accuracy: ±0.2-0.5% Measuring Media: Gas Certificate: ISO and CE Experience: More 20 Years Price: Competitive Specification: CE SGS Wet-test Gas Meter
Main performances
Name and unit

Name and unit	Model
	XML-1	XML-2
Drum capacity(m3)	0.002(2L)	0.005(5L)
Rated flow(m3/h)	0.2(200L)	0.5(500L)
Top flow (m3)	100	100
Excess flow(m3/h)	0.3(300L)	0.75(750L)
Min. scale value(m3)	0.8×10-5	0.2×10-4
Normal pressure (Pa)	1000	1000
Accuracy in rated flow (%)	±1	±1
Pressure in rated flow( Pa≤)	80	80
Outline dimensions(L/W/H)	490×264×220 mm	490×264×304 mm
Net weight(Kg)	4.5	5.4

Measuring medium
XML type is normal-type, it adopts brass material, and generally used in the scope of non-corrosive gases.
XMF type is anticorrosive-type, it adopts stainless steel material, can measure corrosive gases.

Usage
1. Put the meter on the worktable, adjust screws to enable blister of leveler in the centre, and maintain for a long time in use.
2. Open sealed screw cap of water level controller, pull out internal wool rope.
3. In the plug jack of thermometer or manometer, inject distilled water into the meter, when redundant distilled water drain from hole of water level controller ( sometimes it is clean when outflow one drop), then put wool rope in sealed screw cap of water level controller, and fasten the sealed screw cap.
4. Install thermometer and manometer, (every case 10Pa)
5. Connect air channel according to direction of gas outlet and intake, and sealled.
6. Open gas valve, and then you can measure gas.

Attentions while using
1. When you use it, you must always pay attention to the water level in the meter, otherwise it will affect measuring accuracy.
2. When you use it, temperature should be maintained at 15 ~ 25 ºC, and the temperature is the same as room temperature, its temperature difference should be ≤ 2 ºC.
3. You'd better readout in a few weeks after the operation of the meter.
4. When pressure of measuring gas is go beyond normal pressure 1 ~ 6 times (1 ~ 6 KPa), the meters can still work, at this time manometer should be removed , then use rubber plug plugs up mounting holes of manometer.
5. When flow of measuring gas is go beyond rated flow, the meters can still work, but measuring accuracy will be greatly decreased.
7. The meter should not be installed in a cold room, for fear that it will freeze inside.
8. In normal circumstances, check out accuracy every year at least.

Accessories
1 pc of thermometer
1 pc of manometer
2 rubber plugs

Production flow:

Installation:

Contact us if you need more details on Drum Gas Flowmeter. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Wet Gas Flow Meter、Wet Gas Meter. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Flow Meters > Flow Meter For Gas